Linux version 3.19.0 (landley@halfbrick) (gcc version 4.2.1) #1 Wed Apr 29 12:55:16 CDT 2015
Early serial console at I/O port 0x3f8 (options '38400n8')
bootconsole [uart0] enabled
CPU0 revision is: 00019300 (MIPS 24Kc)
FPU revision is: 00739300
Software DMA cache coherency enabled
Determined physical RAM map:
 memory: 00001000 @ 00000000 (reserved)
 memory: 000ef000 @ 00001000 (ROM data)
 memory: 003e1000 @ 000f0000 (reserved)
 memory: 07b2f000 @ 004d1000 (usable)
Wasting 39456 bytes for tracking 1233 unused pages
Initial ramdisk at: 0x804e0000 (477841 bytes)
Zone ranges:
  DMA      [mem 0x00000000-0x00ffffff]
  Normal   [mem 0x01000000-0x07ffffff]
Movable zone start for each node
Early memory node ranges
  node   0: [mem 0x00000000-0x07ffffff]
Initmem setup node 0 [mem 0x00000000-0x07ffffff]
Primary instruction cache 2kB, VIPT, 2-way, linesize 16 bytes.
Primary data cache 2kB, 2-way, VIPT, no aliases, linesize 16 bytes
Built 1 zonelists in Zone order, mobility grouping on.  Total pages: 32512
Kernel command line: rd_start=0xffffffff804e0000 rd_size=477841 panic=1 console=ttyS0 HOST=mipsel 
PID hash table entries: 512 (order: -1, 2048 bytes)
Dentry cache hash table entries: 16384 (order: 4, 65536 bytes)
Inode-cache hash table entries: 8192 (order: 3, 32768 bytes)
Writing ErrCtl register=00000000
Readback ErrCtl register=00000000
Memory: 124504K/131072K available (2878K kernel code, 168K rwdata, 476K rodata, 180K init, 195K bss, 6568K reserved, 0K cma-reserved)
SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1
NR_IRQS:256
CPU frequency 200.00 MHz
Console: colour dummy device 80x25
Calibrating delay loop... 823.29 BogoMIPS (lpj=1646592)
pid_max: default: 32768 minimum: 301
Mount-cache hash table entries: 1024 (order: 0, 4096 bytes)
Mountpoint-cache hash table entries: 1024 (order: 0, 4096 bytes)
devtmpfs: initialized
NET: Registered protocol family 16
vgaarb: loaded
SCSI subsystem initialized
PCI host bridge to bus 0000:00
pci_bus 0000:00: root bus resource [mem 0x10000000-0x17ffffff]
pci_bus 0000:00: root bus resource [io  0x1000-0x1fffff]
pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff]
pci 0000:00:00.0: [Firmware Bug]: reg 0x14: invalid BAR (can't size)
pci 0000:00:00.0: [Firmware Bug]: reg 0x18: invalid BAR (can't size)
pci 0000:00:00.0: [Firmware Bug]: reg 0x1c: invalid BAR (can't size)
pci 0000:00:00.0: [Firmware Bug]: reg 0x20: invalid BAR (can't size)
pci 0000:00:00.0: [Firmware Bug]: reg 0x24: invalid BAR (can't size)
pci 0000:00:0a.1: legacy IDE quirk: reg 0x10: [io  0x01f0-0x01f7]
pci 0000:00:0a.1: legacy IDE quirk: reg 0x14: [io  0x03f6]
pci 0000:00:0a.1: legacy IDE quirk: reg 0x18: [io  0x0170-0x0177]
pci 0000:00:0a.1: legacy IDE quirk: reg 0x1c: [io  0x0376]
pci 0000:00:0a.3: quirk: [io  0x1000-0x103f] claimed by PIIX4 ACPI
pci 0000:00:0a.3: quirk: [io  0x1100-0x110f] claimed by PIIX4 SMB
vgaarb: device added: PCI:0000:00:12.0,decodes=io+mem,owns=none,locks=none
pci 0000:00:12.0: BAR 0: assigned [mem 0x10000000-0x11ffffff pref]
pci 0000:00:0b.0: BAR 6: assigned [mem 0x12000000-0x1203ffff pref]
pci 0000:00:12.0: BAR 6: assigned [mem 0x12040000-0x1204ffff pref]
pci 0000:00:12.0: BAR 1: assigned [mem 0x12050000-0x12050fff]
pci 0000:00:0a.2: BAR 4: assigned [io  0x1040-0x105f]
pci 0000:00:0b.0: BAR 0: assigned [io  0x1060-0x107f]
pci 0000:00:0b.0: BAR 1: assigned [mem 0x12051000-0x1205101f]
pci 0000:00:0a.1: BAR 4: assigned [io  0x1080-0x108f]
Switched to clocksource MIPS
NET: Registered protocol family 2
TCP established hash table entries: 1024 (order: 0, 4096 bytes)
TCP bind hash table entries: 1024 (order: 0, 4096 bytes)
TCP: Hash tables configured (established 1024 bind 1024)
TCP: reno registered
UDP hash table entries: 256 (order: 0, 4096 bytes)
UDP-Lite hash table entries: 256 (order: 0, 4096 bytes)
NET: Registered protocol family 1
PCI: Enabling device 0000:00:0a.2 (0000 -> 0001)
Unpacking initramfs...
Freeing initrd memory: 464K (804e0000 - 80554000)
futex hash table entries: 256 (order: -1, 3072 bytes)
squashfs: version 4.0 (2009/01/31) Phillip Lougher
9p: Installing v9fs 9p2000 file system support
io scheduler noop registered (default)
Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled
console [ttyS0] disabled
serial8250.0: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A
console [ttyS0] enabled
console [ttyS0] enabled
bootconsole [uart0] disabled
bootconsole [uart0] disabled
serial8250.0: ttyS1 at I/O 0x2f8 (irq = 3, base_baud = 115200) is a 16550A
serial8250.0: ttyS2 at MMIO 0x1f000900 (irq = 20, base_baud = 230400) is a 16550A
loop: module loaded
Uniform Multi-Platform E-IDE driver
piix 0000:00:0a.1: IDE controller (0x8086:0x7111 rev 0x00)
PCI: Enabling device 0000:00:0a.1 (0000 -> 0001)
piix 0000:00:0a.1: not 100% native mode: will probe irqs later
    ide0: BM-DMA at 0x1080-0x1087
    ide1: BM-DMA at 0x1088-0x108f
hdc: QEMU DVD-ROM, ATAPI CD/DVD-ROM drive
hdc: UDMA/33 mode selected
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
ide-gd driver 1.18
ide-cd driver 5.00
ide-cd: hdc: ATAPI 4X DVD-ROM drive, 512kB Cache
cdrom: Uniform CD-ROM driver Revision: 3.20
pcnet32: pcnet32.c:v1.35 21.Apr.2008 tsbogend@alpha.franken.de
PCI: Enabling device 0000:00:0b.0 (0000 -> 0003)
pcnet32: PCnet/PCI II 79C970A at 0x1060, 52:54:00:12:34:56 assigned IRQ 10
pcnet32: eth0: registered as PCnet/PCI II 79C970A
pcnet32: 1 cards_found
TCP: cubic registered
NET: Registered protocol family 17
9pnet: Installing 9P2000 support
drivers/rtc/hctosys.c: unable to open rtc device (rtc0)
Freeing YAMON memory: 956k freed
Freeing unused kernel memory: 180K (80473000 - 804a0000)
pcnet32 0000:00:0b.0 eth0: link up
mount: '/dev/hdc'->'/mnt': No medium found
Type exit when done.
(mipsel:1) / # gcc -s /usr/src/thread-hello2.c -lpthread -o /tmp/hello
/bin/ash: gcc: not found
(mipsel:1) / # /tmp/hello
/bin/ash: /tmp/hello: not found
(mipsel:1) / # exit
reboot: Restarting system