Linux version 3.18.0 (landley@halfbrick) (gcc version 4.2.1) #1 Mon Mar 9 00:05:25 CDT 2015 Early serial console at I/O port 0x3f8 (options '38400n8') bootconsole [uart0] enabled CPU0 revision is: 000182a0 (MIPS 20Kc) FPU revision is: 000f8200 Checking for the multiply/shift bug... no. Checking for the daddiu bug... no. Software DMA cache coherency enabled Determined physical RAM map: memory: 0000000000001000 @ 0000000000000000 (reserved) memory: 00000000000ef000 @ 0000000000001000 (ROM data) memory: 000000000043b000 @ 00000000000f0000 (reserved) memory: 0000000007ad4000 @ 000000000052b000 (usable) Wasting 74088 bytes for tracking 1323 unused pages Initial ramdisk at: 0x9800000000530000 (482402 bytes) Zone ranges: DMA [mem 0x00000000-0x00ffffff] Normal [mem 0x01000000-0x07ffefff] Movable zone start for each node Early memory node ranges node 0: [mem 0x00000000-0x07ffefff] Initmem setup node 0 [mem 0x00000000-0x07ffefff] Primary instruction cache 32kB, VIVT, 4-way, linesize 32 bytes. Primary data cache 32kB, 4-way, PIPT, no aliases, linesize 32 bytes Built 1 zonelists in Zone order, mobility grouping on. Total pages: 32319 Kernel command line: rd_start=0xffffffff80530000 rd_size=482402 panic=1 console=ttyS0 HOST=mips64 PID hash table entries: 512 (order: 0, 4096 bytes) Dentry cache hash table entries: 16384 (order: 5, 131072 bytes) Inode-cache hash table entries: 8192 (order: 4, 65536 bytes) Enable cache parity protection for MIPS 20KC/25KF CPUs. Memory: 123268K/131068K available (2931K kernel code, 260K rwdata, 596K rodata, 228K init, 235K bss, 7800K reserved) SLUB: HWalign=64, Order=0-3, MinObjects=0, CPUs=1, Nodes=1 NR_IRQS:256 CPU frequency 300.00 MHz Console: colour dummy device 80x25 Calibrating delay loop... 2461.69 BogoMIPS (lpj=4923392) pid_max: default: 32768 minimum: 301 Mount-cache hash table entries: 512 (order: 0, 4096 bytes) Mountpoint-cache hash table entries: 512 (order: 0, 4096 bytes) Checking for the daddi bug... no. devtmpfs: initialized NET: Registered protocol family 16 vgaarb: loaded SCSI subsystem initialized PCI host bridge to bus 0000:00 pci_bus 0000:00: root bus resource [mem 0x10000000-0x17ffffff] pci_bus 0000:00: root bus resource [io 0x1000-0x1fffff] pci_bus 0000:00: No busn resource found for root bus, will use [bus 00-ff] pci 0000:00:0a.1: legacy IDE quirk: reg 0x10: [io 0x01f0-0x01f7] pci 0000:00:0a.1: legacy IDE quirk: reg 0x14: [io 0x03f6] pci 0000:00:0a.1: legacy IDE quirk: reg 0x18: [io 0x0170-0x0177] pci 0000:00:0a.1: legacy IDE quirk: reg 0x1c: [io 0x0376] pci 0000:00:0a.3: quirk: [io 0x1000-0x103f] claimed by PIIX4 ACPI pci 0000:00:0a.3: quirk: [io 0x1100-0x110f] claimed by PIIX4 SMB vgaarb: device added: PCI:0000:00:12.0,decodes=io+mem,owns=none,locks=none pci 0000:00:12.0: BAR 0: assigned [mem 0x10000000-0x11ffffff pref] pci 0000:00:0b.0: BAR 6: assigned [mem 0x12000000-0x1203ffff pref] pci 0000:00:12.0: BAR 6: assigned [mem 0x12040000-0x1204ffff pref] pci 0000:00:12.0: BAR 1: assigned [mem 0x12050000-0x12050fff] pci 0000:00:0a.2: BAR 4: assigned [io 0x1040-0x105f] pci 0000:00:0b.0: BAR 0: assigned [io 0x1060-0x107f] pci 0000:00:0b.0: BAR 1: assigned [mem 0x12051000-0x1205101f] pci 0000:00:0a.1: BAR 4: assigned [io 0x1080-0x108f] Switched to clocksource MIPS NET: Registered protocol family 2 TCP established hash table entries: 1024 (order: 1, 8192 bytes) TCP bind hash table entries: 1024 (order: 1, 8192 bytes) TCP: Hash tables configured (established 1024 bind 1024) TCP: reno registered UDP hash table entries: 256 (order: 1, 8192 bytes) UDP-Lite hash table entries: 256 (order: 1, 8192 bytes) NET: Registered protocol family 1 PCI: Enabling device 0000:00:0a.2 (0000 -> 0001) Unpacking initramfs... Freeing initrd memory: 468K (9800000000530000 - 98000000005a5000) futex hash table entries: 256 (order: 0, 6144 bytes) squashfs: version 4.0 (2009/01/31) Phillip Lougher 9p: Installing v9fs 9p2000 file system support msgmni has been set to 241 io scheduler noop registered (default) Serial: 8250/16550 driver, 4 ports, IRQ sharing disabled console [ttyS0] disabled serial8250 serial8250.0: ttyS0 at I/O 0x3f8 (irq = 4, base_baud = 115200) is a 16550A console [ttyS0] enabled console [ttyS0] enabled bootconsole [uart0] disabled bootconsole [uart0] disabled serial8250 serial8250.0: ttyS1 at I/O 0x2f8 (irq = 3, base_baud = 115200) is a 16550A loop: module loaded Uniform Multi-Platform E-IDE driver piix 0000:00:0a.1: IDE controller (0x8086:0x7111 rev 0x00) PCI: Enabling device 0000:00:0a.1 (0000 -> 0001) piix 0000:00:0a.1: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1080-0x1087 ide1: BM-DMA at 0x1088-0x108f hdc: QEMU DVD-ROM, ATAPI CD/DVD-ROM drive hdc: UDMA/33 mode selected ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 ide-gd driver 1.18 ide-cd driver 5.00 ide-cd: hdc: ATAPI 4X DVD-ROM drive, 512kB Cache cdrom: Uniform CD-ROM driver Revision: 3.20 pcnet32: pcnet32.c:v1.35 21.Apr.2008 tsbogend@alpha.franken.de PCI: Enabling device 0000:00:0b.0 (0000 -> 0003) pcnet32: PCnet/PCI II 79C970A at 0x1060, 52:54:00:12:34:56 assigned IRQ 10 pcnet32: eth0: registered as PCnet/PCI II 79C970A pcnet32: 1 cards_found TCP: cubic registered NET: Registered protocol family 17 9pnet: Installing 9P2000 support drivers/rtc/hctosys.c: unable to open rtc device (rtc0) Freeing YAMON memory: 956k freed Freeing unused kernel memory: 228K (ffffffff804b7000 - ffffffff804f0000) thread -o /tmp/hello /tmp/hello exit Kernel panic - not syncing: Attempted to kill init! exitcode=0x0000000a Rebooting in 1 seconds..